Q-Tech Engineering Services

S-134, C/o Precision Engineering Works MIDC, Bhosari, Pune, Maharashtra, 411026, India

8237013585

qtech.services2012@gmail.com

Other Branches:

N/A
Scope of Accrediation
Instruments
S.No. Instrument Name Range (to & from ) CMC (to & from )
1 External Micrometer L.C. 1 µmΦ 0 mm To 100 mm 1.4 μm
2 Depth Micrometer L.C.10 µm$ 0 mm To 300 mm 8.8 μm
3 Internal Micrometer L.C. 10 µm$ 0 mm To 600 mm 8.2 μm
4 Caliper L.C. 0.01mm$ 0 mm To 600 mm 15.0 μm
5 Height Gauge L.C. 0.01 mmΦ 0 mm To 600 mm 15.0 μm
6 Depth Gauge L.C. 0.01 mmΦ 0 mm To 30 mm 15.0 μm
7 Plunger Dial Gauge L.C. 0.001 mm$ 0 mm To 1 mm 1.2 μm
8 Lever Type Dial Gauge L.C.0.001 mmΦ 0 mm To 0.2 mm 1.8 μm
9 Dial Gauge (Lever Type) L.C. 0.01 mm$ 0 mm To 1 mm 5.9 μm
10 Dial Bore Gauge$ 0 mm To 2 mm 4.0
NOTE: All Symbols and their description

* : Meaurement Capability is expressed as an uncertainty (±) at a Confidence probability of 95 %

$ : Only in Permanent Laboratory

♣ : Only for Site Calibration

# : The laboratory is also capable for site calibration however, the uncertainty at site depends on the prevailing actual environmental conditions and master equipment used

Φ : Laboratory can also Caibrate instruments/devices of coarser resolution/ least count within the accredited range using same reference standard/ master equipment under the scope of accreditation

Accrediation valid upto
13-05-2017

About Q-Tech Engineering Services

Q-Tech Engineering services was established in 2011 and is located at Pune, Maharashtra. It is involved in the manufacturing and service providing for various instruments. It offers Mechanical Calibration services for measuring quantities such as Dimension using instruments such as External Micrometer, Depth Micrometer, Internal Micrometer, Caliper, Height Gauge, Depth Gauge, Plunger and Lever Dial Gauge, Bore Gauge, Dial Snap Gauge, Pistol Caliper, Bevel Protractor, Angle Protractor, Combination Set, Plain Plug Gauge, Snap Gauge, Thread Plug Gauge, Feeler Gauge, Cylindrical Setting Master, Measuring Pin, Micrometer Setting Standard, Plain Ring Gauge, Coating Thickness Gauge, Dial Calibration Tester, Electronic Probe, Comparator Stand, Inside Dial Caliper, V Block, Engineers Square, Angle Plate, ‘V’ Anvil Micrometer, Caliper Checker, and others. Q-Tech Engineering services has been accredited with ISO/IEC 17025: 2005 for their Calibration disciplines.