Valco Calibration Services

S Block, Plot No. 230/1, MIDC - Bhosari, Pune, Maharashtra, 411 026, India




Other Branches:

Scope of Accrediation
S.No. Instrument Name Range (to & from ) CMC (to & from )
1 Caliper L.C.10 µmΦ 0 mm To 600 mm 16.0 μm
2 Depth Caliper L.C 10 µm$ 0 mm To 600 mm 13.0 μm
3 Height Gauge L.C. 10 µm$ 0 mm To 600 mm 12.42 μm
4 External Micrometer L.C. 0.001 mm$ 0 mm To 100 mm 1.53 μm
5 External Micrometer L.C. 0.01 mm$ 0 mm To 300 mm 6.80 μm
6 Internal Micrometer (Two Point) L.C. 0.01 mm $ 50 mm To 63 mm 1.30 μm
7 Internal Micrometer/ Stick Micrometer/ Micrometer Head Extension Rod L.C. 10 µm$ 0 mm To 300 mm 8.00 μm
8 Depth Micrometer L.C. 0.001 mm$ 0 mm To 100 mm 1.8 μm
9 Depth micrometer L.C. 0.01mm$ 0 mm To 300 mm 6.0 μm
10 Micrometer Setting Standard$ 0 mm To 300 mm 3.50 μm
NOTE: All Symbols and their description

* : Meaurement Capability is expressed as an uncertainty (±) at a Confidence probability of 95 %

$ : Only in Permanent Laboratory

♣ : Only for Site Calibration

# : The laboratory is also capable for site calibration however, the uncertainty at site depends on the prevailing actual environmental conditions and master equipment used

Φ : Laboratory can also Caibrate instruments/devices of coarser resolution/ least count within the accredited range using same reference standard/ master equipment under the scope of accreditation

Accrediation valid upto

About Valco Calibration Services

Valco Calibration Services is located at MIDC- Bhosari, Pune, Maharashtra. Valco Calibration Services provides Mechanical Calibration services for measuring quantities such as Dimension using Instruments such as Vernier or Dial or Digital Caliper, Vernier or Dial or Digital Depth Caliper, Vernier or Dial or Digital Height Gauge, External Micrometer, Overall Length Accuracy with Extension Rod, Depth Micrometer, Micrometer Setting Standard, Plunger Type and Lever Type Dial Gauge, Bore Gauge with Dial, Dial Thickness Gauge, Dial Snap Gauge, Plain Plug Gauge, Plain Ring Gauge, Snap Gauge, Cylindrical Measuring Pin, Cylindrical Setting Master, Length Bar, Plain Threaded Plug Gauge, Plain Threaded Ring Gauge, Thread Measuring Wire, Plain Taper Plug Gauge, Plain Taper Ring Gauge, Feeler Gauge, Bevel Protractor, Combination Set Angle Protractor, Straight Edge, Angle Plate, Box Angle Plate, Engineers Square, V-Block, Comparator Stand, Pistol Caliper, Electronic Height Gauge, Surface Plate Flatness. Valco Calibration Services has been accredited with ISO/IEC 17025: 2005 by NABL.