Central Mechanical Engineering Research Institute

Mahatma Gandhi Avenue,, Durgapur, West Bengal, 713209, India

0343 651 0701

rsen@cmeri.res.in

Other Branches:

N/A
Scope of Accrediation
Instruments
S.No. Instrument Name Range (to & from ) CMC (to & from )
1 Gauge Blocks$ 0.5 mm To 25 mm 0.11 μm
2 Length Bars $ 0 mm To 300 mm 1.1 μm
3 Plain Plug Gauge$ 0 mm To 600 mm 1.5 μm
4 Plain Gap Gauge $ 0 mm To 600 mm 1.5 μm
5 Snap Gauge$ 0 mm To 600 mm 1.5 μm
6 External Micrometer L.C. 0.001 mm$ 0 mm To 25 mm 1.2 μm
7 External Micrometer L.C. 0.01mm$ 0 mm To 100 mm 2.5 μm
8 Internal Micrometer L.C. 0.01 mm$ 0 mm To 100 mm 2.5 μm
9 Height Gauge L.C. 0.02 mm$ 0 mm To 300 mm 2.0 μm
10 Height Gauge L.C. 0.001 mm$ 0 mm To 1000 mm 4.0 μm
NOTE: All Symbols and their description

* : Meaurement Capability is expressed as an uncertainty (±) at a Confidence probability of 95 %

$ : Only in Permanent Laboratory

♣ : Only for Site Calibration

# : The laboratory is also capable for site calibration however, the uncertainty at site depends on the prevailing actual environmental conditions and master equipment used

Φ : Laboratory can also Caibrate instruments/devices of coarser resolution/ least count within the accredited range using same reference standard/ master equipment under the scope of accreditation

Accrediation valid upto
21-05-2016

About Central Mechanical Engineering Research Institute

Central Mechanical Engineering Research Institute has been into existence for more than 50 years. The purpose of the institute is to boost the development of mechanical engineering sector of the country. Technologies, goods and services associated with the mechanical engineering industry occupy a large segment of the imports. CMERI is undertaking an initiative in which it aims to cut down the cost of imports by getting hold of the technology in a better way. Conducting calibration is a service that can help to improve the mechanical engineering services in the country, therefore the institute has itself established a calibration laboratory facility. The calibration facility is located in the city of Durgapur in West Bengal where thermal and mechanical calibration processes are undertaken. Dimension, pressure, vacuum, mass, volume and density are calibrated through mechanical calibration instruments. Temperatures are calibrated through thermal calibration instruments. Since its inception it has been providing superior standard of services. This can be attributed to its technological advancements and committed workforce.